E-pack200 DMR Digital Wireless Ad Hoc Dual Channel Repeater (UHF or VHF)

E-pack200 DMR

Repeaters & Systems | Fast Deployment | DMR

Hytera's E-pack200 repeater is intended for fast and flexible communication system deployment. The highly portable E-pack200 can not only be used as a radio to make and receive calls, it can also create a wireless mobile Ad Hoc network for voice routing. One E-pack200 can function as a radio, repeater, and mesh node with one frequency, greatly saving frequency resources. The E-pack200 repeater is a huge advance in the wireless ad hoc network (WANET) repeater portfolio, designed to offer dual communication paths simultaneously and precise positioning services, providing an all-round networking solution for those engaged in firefighting, disaster relief, VIP security, public safety management, and more. There are two versions of the E-pack200 repeater available, the VHF version or the UHF version. The custom operating frequencies are VHF 136- 174Mhz & UHF 400-470 MHz pre-set frequency range, allowing efficient usage of channel resources. With it’s light, small and IP67 design, the E-Pack200 can be installed in a vehicle, carried in a backpack, or be pole or wall-mounted making it suitable for deployment as temporary communication or to provide or extend indoor coverage.

Highlights of E-pack200 DMR

Fast deployment, create network in seconds

In emergency situations, every second counts. The E-pack200 repeater supports push-to-start for quickly and automatically establishing an independent network after power-on so as to efficiently extend radio coverage.

Dual Channel Voice Transmit

The repeater can repeat voice services on two channels simultaneously using 4 independent carrier frequencies (channel spacing: 12.5 kHz).

Remote management, keep networking status always known

The ad hoc network created by the E-pack200 repeaters can be monitored by the network management system including the network topologies and the electric field strength of the E-pack200.

Wireless Mobile Ad-Hoc Networking

The Hytera E-pack200 can create a wireless ad-hoc network, in which there are a maximum of 31 nodes. The ad-hoc network is self-configuring and dynamic in which E-pack nodes are free to move.

Blind Area Coverage

Due to the high output power of the E-pack200, communications will not be affected by the topology of the area, different floors or obstacles etc.

Free of any IP link, flexible topology networking

The repeater adopts wireless interconnection technology to quickly create multi-hop narrowband networks through cascading connection, free of any IP link such as fiber optic and microwave.

LTE link as backup, offer a ways-reliable communication solution

When the PMR network is down, the E-pack200 repeater with a SlM card can keep repeating calls or data over the LTE network. Also, it can access the command and dispatch system.

Data encryption, protect data and device

The E-pack200 repeater has multiple security mechanisms such as authentication, software and hardware encryption to protect the data and privacy. It can be disabled temporarily or permanently through the dispatch and command system to prevent unauthorized access.

Specifications of E-pack200 DMR

  • General
  • Receiver
  • Transmitter
  • Environmental
  • Location Service
General
Frequency 400-470 MHz 136-174 MHz
Protocol DMR conventional (Tier II)
Networking capacity 31
Channel spacing 12.5 kHz
Rated voltage 14.8 V DC
Current consumption < 1 A (standby) < 2.5 A (at 20W transmit power)
Battery capacity (optional) 148 Wh
Charging time Rapid charge 2h 80%; 3h fully charged
Battery life About 9 hours (15–85 duty cycle)
Frequency stability ±0.5 ppm
Antenna impedance 50 Ω
Dimensions (H x W x D) in mm 211 x 62 x 235
Weight 3.1 kg (with battery)
Receiver
Static Rx sensitivity -122 dBm @ 5% BER
Adjacent channel selectivity ETSI: 60 dB @12.5 kHz / 70 dB @25 kHz
Intermodulation response rejection ≥ 70 dB
Spurious response rejection ≥ 70 dB
Blocking 84dB
Conducted spurious emission -57 dBm (at 9 kHz to 1 GHz) -47 dBm (at 1 GHz to 12.75 GHz)
Transmitter
Output power 1W / 5W / 10W (per way)
Adjacent channel power 60 dB @12.5 kHz 70 dB @25 kHz
Vocoder type AMBE+2™/NVOC
Environmental
Operating temperature -30°C to +60°C
Storage temperature -40°C to +85°C
ESD IEC 61000-4-2 (level 4) ±8 kV (contact discharge) ±15 kV (air discharge)
Waterproof & Dustproof IP67
Shock and Vibration MIL-STD-810 C/D/E/F/G
Humidity MIL-STD-810 C/D/E/F/G
Location Service
GNSS GPS
TTFF (time to first fix) cold start < 1 minute
TTFF (time to first fix) hot start < 10 seconds
Horizontal position accuracy < 10 meters
Note Suitable for long-term tracking (5 satellites visible at the rated signal strength of -130 dBm)
hytera video player